HQRP Solar 10A Charge Power Controller / Regulator 12V / 24V 10 Amp with LED
HQRP Solar 10A Charge Power Controller / Regulator 12V / 24V 10 Amp with LED Indicator plus HQRP Coaster
- HQRP® Solar Charge Controller plus HQRP® Coaster;
- Equalisationvoltage: 14.8 Volt; High voltage disconnect: 14.4;
- Float voltage: 13.6Volt; Low voltage disconnect: 11.1 Volt;
- Low voltage reconnect: 12.6 Volt; Self-consumption: 6mA maximum;
- Terminals: for wire sizes to 6mm2; PWM charge mode & state of charge (SOC). 200 days warranty!
Products trademarked HQRP® are marketed and sold exclusively by Osprey-Talon. HQRP Solar Charge Controllers are high quality, efficient and reliable Solar Power Regulators. They are perfect for rural electrification system. They offer a lot of possibilities and benefits. Regulations point: 14.4 Volts; Low voltage Disconnect: 11.1V Volts; Low voltage Reconnect: 13.1 Volts; Microcontroller digital accuracy; Type of Charging: Series PWM & stat of charge(SOC); 4 Stages: equalization, PWM, Boost and Float, temperature compensated charging; Electronic protections: Short circuit and over current-solar and load; Reverse current at night; Limits high voltage to protect loads; Lighting protection; Tropicalization Conformal coated printed circuit board; Terminals For wire sizes to 6mm2; Self-consumption: 6mA maximum. Solar Controller supports up to 150W of 12V Solar panels and up to 300W of 24V Solar panels. For 12V solar panels, please, use battery and load for 12V solar systems (For 24V solar
List Price: $ 29.91
Price: $ 29.91
Also Recommended:
ReVIVE Series Solar Rechargeable Back-Up POWER Boost for Kindle, iPhone, Blackberry, Windows and Android Phones – Includes AC adapter and USB Cable for ChargingSOLAR POWER Boost Powerful enough to charge all of your portable electronics using the POWER of the SUN!Provides a source of POWER…
Solar Electricity Handbook – 2011 EditionThe Solar Electricity Handbook is a simple, practical guide to using electric solar panels and designing and installing photovol…
Premium Solar Charger – Ultra Thin Solar Powered Backup Battery and Charger for Cell Phones, iPhone, iPod, and Most USB Powered Device – Also Includes Built-in LED Reading Light and Window / Windshield Suction CupsThe XTG Technology ultra-slim “Solar Portable Battery and Charger” is the perfect solution for emergency power and power on the go…
Find More Solar Power Products
This Post Has 2 Comments
Good PWM charger for the cost,
I’m satisfied with this PWM PV charge controller. Compared to other charge controllers and even those of PWM or MPPT, this one has the best cost. Only around $30 compared to those that do the same and cost around in the $100’s. With PWM techonlogy, the charger is neither on or off like some of the cheaper controllers. Instead it regulates the voltage so it is constantly chargeing and then float chargers when the batteries are full. Also, because the voltage is being regulated closer to the batteries voltage. The batteries do not gas as much. A second thing with PWM controller, the batteries receive pulses of a charge, similar to a battery desulfator. So the batteries plates will not sulfate as much either. I found the charger regualtes the voltage .5V higher than the batteries readings. And float regulate around 13.3V. Controller can handle up to 10Amps (150Watts of PV power) and can control discharge through the controler at 10Amps. Which makes it good for outdoor ligthing or ponds where if the batteries become too low, the controller will automatically shut them down until the batteries are fully recharged.
Was this review helpful to you?
|Great unit for solar lighting, pumps, fountains and more,
Here’s why this thing rocks:
– good screw terminal connections
– connections for the solar panel, a battery, AND (this is key) a device you want to hook up TO the solar/battery system.
This last point is awesome – it provides a no-brainer way to hook up a device to a regulated / protected solar /battery system, and allows you to use the battery for power when the sun goes down or during cloudy periods – in fact, the system automatically delivers power from the battery as needed.
– Also critical is a Low Voltage Disconnect – for a solar fountain project, I first used another product without the LVD – my battery was drained completely overnight, and batteries discharged 100% can’t be recharged easily (they register as an open circuit or cause other problems). This unit takes away that worry.
– The unit has a switch on it so you can turn on/off the device you’re powering right from the unit.
The unit seems to be designed for rural electrification (i.e. remote villages in india needing electric lights at night). It has a conformal coating on the circuit board (anti-rust).
For me, I combined a 500 gph Rule bilge pump, this unit, a 30 watt 12 volt solar panel, and a cheap $35 12 volt tractor battery and I have an AWESOME solar fountain. I’m pretty psyched on this device, and just ordered 2 more.
Was this review helpful to you?
|